| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The Nuvoton NPCX eSPI driver parses Target-Attached-Flash (TAF) requests in espi_taf_parse() (drivers/espi/espi_npcx.c), taking the 12-bit length field directly out of the request header in the FLASHRXBUF FIFO. For write and RPMC OP1 requests it copied DIV_ROUND_UP(len, 4) words into struct espi_taf_pckt.src, a fixed 16-word (64-byte) member of a static structure, without ever comparing the length against that buffer or against the negotiated eSPI receive payload size (rx-plsize, 64 bytes on all in-tree NPCX/NPCK SoCs). Both the loop counter and the word count were uint8_t, so the copy ran up to 255 iterations.
An eSPI controller that emits a flash request whose header claims a payload larger than the negotiated maximum therefore drives up to 239 32-bit stores past the end of the structure — roughly 956 bytes of out-of-bounds write into .bss — from the eSPI flash receive interrupt handler, while the source reads walk past the end of the 18-word FLASHRXBUF register array into neighbouring eSPI registers. The same unvalidated length was then passed on to flash_write() in espi_taf_npcx_flash_write() with the 64-byte src buffer as source, reading up to 4 KB of adjacent controller SRAM into SPI flash at a host-chosen address, where the host can read it back. A related fixed-size stack buffer in taf_npcx_completion_handler() was overflowed by four bytes on the maximum-size completion path on SoCs whose tx-plsize is 64.
The defect is reachable only from the eSPI host side, and only by a request that violates the negotiated payload size, so it requires host firmware or bus-level control rather than ordinary host software; a compliant maximum-length write fits the buffer exactly and is handled correctly. Because TAF exists specifically so that the embedded controller arbitrates host access to shared flash (espi_taf_check_read_protect() / espi_taf_check_write_protect()), corrupting controller memory from a host-supplied field crosses the trust boundary the feature asserts; consequences range from controller crash or hang to corruption of driver state that gates the flash protection regions.
The fix widens the counters, rejects any request whose word count exceeds both ARRAY_SIZE(FLASHRXBUF) - NPCX_ESPI_FLASH_HEADER_ADDRESS_LEN and NPCX_TAF_RX_PAYLOAD_WORDS (derived from the devicetree rx-plsize), marks such packets with a new invalid_flag so espi_taf_work() answers them with an unsuccessful completion instead of processing them, bounds the transmit payload against FLASHTXBUF, and adds a default case for unsupported cycle types. Only configurations with CONFIG_ESPI_TAF enabled on an NPCX/NPCK target are affected; no in-tree board enables it by default. |
| Out-of-bounds read and write in the Count-Min sketch deserialization of Apache DataSketches C++ (repo: datasketches-cpp).
count_min_sketch::deserialize() did not include the preamble in its input size check, so a truncated sketch could cause a read of up to 16 bytes past the end of the input. In addition, the table size was computed from the serialized number of buckets and number of hash functions in 32-bit arithmetic. A crafted sketch could make it wrap to zero, so that the sketch deserialized with an empty table, and later updates and estimate queries read and wrote outside the heap allocation. This can corrupt heap memory, causing a crash and potentially enabling further exploitation.
This issue affects Apache DataSketches C++: from 4.1.0 before 5.3.0. Only applications that deserialize Count-Min sketches from untrusted sources are affected.
Users are recommended to upgrade to version 5.3.0, which fixes this issue. |
| A flaw was found in mod_qos. An unauthenticated remote attacker can cause a Denial of Service (DoS) by maintaining numerous concurrent low-rate connections to a target server. When connection rate monitoring is active, the module fails to verify array boundaries when recording client IP addresses, allowing more connection records to be added than the allocated buffer can hold. This issue leads to heap memory corruption, which can crash the web server process. |
| Pillow is a Python imaging library. From 9.4.0 until 13.0.0, ImagingJpegEncode() in src/libImaging/JpegEncode.c can call jpeg_write_marker() for a JPEG COM comment when an ICC profile has exactly filled the 65536-byte encoder buffer. libjpeg writes one byte before checking the exhausted free_in_buffer counter, which then wraps and permits the attacker-controlled comment and subsequent compressed image data to overwrite adjacent heap memory. Re-saving an untrusted image as JPEG while preserving its ICC profile and forwarded comment can crash the process and may enable code execution in suitable runtime and heap layouts. This issue is fixed in version 13.0.0. |
| Pillow is a Python imaging library. From 11.0.0 until 13.0.0, multi-frame loaders can retain an ImagingCore allocation created for a narrow frame mode while a later frame of the same dimensions changes the logical mode and decoder tiles to wider RGB or CMYK data. ImageFile.load_prepare() reuses the stale native storage because _im is non-null without verifying that its mode and size still match. Crafted PSD, MPO, DCX, or MIC frame transitions can then write wider pixels into the narrow allocation, causing native out-of-bounds writes and crashes. The MPO path can also cause a native over-read and, in demonstrated runtime-specific profiles, command execution. This issue is fixed in version 13.0.0. |
| libLAS through 1.8.1 contains a heap out-of-bounds write vulnerability in the point record reader caused by truncating the schema byte size to 16 bits when sizing the point buffer. Attackers can craft a .las file with a LASSchema variable length record whose schema exceeds 65535 bytes, so tools like lasinfo, las2las, or las2txt write attacker-controlled bytes past the heap buffer, causing memory corruption and crashes. |
| Adobe Framemaker is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix BPF_F_CPU validation for sparse CPU IDs
BPF_F_CPU stores the target CPU ID in the upper 32 bits of the map
operation flags. bpf_map_check_op_flags() currently compares that ID
with num_possible_cpus(), which is the number of possible CPUs rather
than a bound on CPU IDs.
On an arm64 QEMU guest with a CPU device-tree hole, the possible CPU
mask was 0,2-3. A userspace program using raw bpf() syscalls creates
a BPF_MAP_TYPE_PERCPU_ARRAY and performs update and lookup operations
for each CPU by setting BPF_F_CPU and the CPU ID in the flags.
With the old check, CPU 1 is incorrectly accepted while valid CPU 3 is
rejected with -ERANGE. The CPU 1 update then reaches the per-CPU map
access path and triggers:
Unable to handle kernel paging request at virtual address ...
pc : __pi_memcpy_generic+0x5c/0x22c
lr : bpf_percpu_array_update+0x2dc/0x2e8
Call trace:
__pi_memcpy_generic
bpf_map_update_value
map_update_elem
__sys_bpf
Check the CPU ID against nr_cpu_ids and cpu_possible() instead. This
rejects CPU IDs outside the valid range and CPUs absent from the
possible mask, while allowing valid sparse CPU IDs. |
| A flaw was found in parted. A heap-based buffer overflow can occur when processing a specially crafted FAT32 filesystem due to an integer calculation error during buffer allocation. A local attacker could exploit this by enticing a user or automated service to open a malicious filesystem image, resulting in an application crash leading to a Denial of Service (DoS) or potential memory corruption. |
| Out-of-bounds write in Windows Kernel allows an authorized attacker to elevate privileges locally. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 6.9.13-56 and 7.1.2-31, a crafted local call to the GetVirtualPixels API can trigger an integer calculation error and write beyond a heap buffer, crashing the server process. This issue is fixed in versions 6.9.13-56 and 7.1.2-31. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 7.1.2-31, a client connected to the distributed pixel cache server can send crafted pixel data that triggers an integer-size calculation error and a heap buffer overwrite, crashing the server. This issue is fixed in version 7.1.2-31. |
| Out of bounds write in Forms in Google Chrome prior to 156.0.8078.47 allowed a remote attacker to potentially execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: Low) |
| A flaw was found in parted. A heap-based buffer overflow exists in libparted's file system resizing logic when handling FAT16 volumes. By convincing a user or administrator to resize a specially crafted FAT16 file system image with malformed directory metadata, an attacker can trigger an oversized read into a fixed-size memory buffer. This issue causes memory corruption, resulting in an application crash and a denial of service (DoS). |
| librtmp in RTMPDump through 2.6 contains an out-of-bounds read and heap out-of-bounds write vulnerability because AMF3_Decode ignores AMF3 property decode failures. Malicious RTMP servers or man-in-the-middle attackers can send oversized AMF3 string lengths, and with the token option DecodeTEA corrupts heap memory and leaks heap bytes. |
| Acrobat for Edge is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| UnRTF by GNU Project is vulnerable to out-of-bounds write. If a user opens an RTF file crafted by an attacker, it may lead to a denial-of-service (DoS) condition. |
| The PNG chunk reader has no notion of chunk ordering. It records whether an IDAT has been seen and whether a tRNS has already supplied transparency, but nothing prevents an IHDR being read a second time.
A PNG carries exactly one IHDR and it is the first chunk. A file that places a second one after IDAT rewrites the image width, height, bit depth and pixel depth *after* the decoded-data buffer has already been allocated and filled from the original values. The pass that reverses the PNG row filters then derives its own extent from the new dimensions and walks the old allocation, moving image bytes past the end of it.
The buffer is allocated by GUIX rather than supplied by the caller, so the application has no way to size it defensively. The decoder is compiled in by default. |
| `_gx_binres_pixelmap_table_load()` in the GUIX binary resource (theme) loader indexes the pixelmap table with a value read verbatim from the resource file and never bounds it against the table size. A crafted theme drives a write of up to roughly 256 KB past the end of the table.
The overflowed buffer is allocated by GUIX itself, through `_gx_system_memory_allocator`, rather than supplied by the caller, so the loader corrupts its own arena. The public API `gx_binres_theme_load()` takes no size parameter, so no amount of caller diligence prevents this.
Reproduces in the shipped default configuration; `GX_BINARY_RESOURCE_SUPPORT` is enabled by default. |
| The GUIX binary resource loader never checks that a font page's glyph range is well formed. `gx_page_header_first_glyph` and `gx_page_header_last_glyph` are read verbatim from the file and only the upper bound of `last_glyph` is validated, so a page declaring `first_glyph > last_glyph` makes `last - first + 1` underflow to a very large unsigned count.
That count is multiplied by a glyph record size to reserve the load buffer, and the multiply is unchecked, so it wraps to a small value and the loader allocates a buffer far smaller than the data it is about to write. The load pass then recomputes the count in a narrower type and writes attacker-controlled glyph records into the undersized buffer. |
