| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the data acquisition (DAQ) component of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured access control policies or cause a denial of service (DoS) condition. The vulnerability exists because the affected software improperly manages system memory resources when inspecting traffic. An attacker could exploit this vulnerability by generating specific traffic patterns for the software to inspect. A successful exploit could allow the attacker to exhaust system memory resources used for traffic inspection. Depending on the configuration, the FTD Software could fail open and cease to inspect traffic or fail closed and result in a DoS condition. This vulnerability may require manual intervention to restore the software. |
| A vulnerability in the Internet Key Exchange Version 2 Mobility and Multihoming Protocol (MOBIKE) feature for the Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak or a reload of an affected device that leads to a denial of service (DoS) condition. The vulnerability is due to the incorrect processing of certain MOBIKE packets. An attacker could exploit this vulnerability by sending crafted MOBIKE packets to an affected device to be processed. A successful exploit could cause an affected device to continuously consume memory and eventually reload, resulting in a DoS condition. The MOBIKE feature is supported only for IPv4 addresses. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to perform a command injection attack. The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by injecting commands into arguments for a specific command. A successful exploit could allow the attacker to execute commands with root privileges. |
| A vulnerability in the TCP syslog module of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to exhaust the 1550-byte buffers on an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to a missing boundary check in an internal function. An attacker could exploit this vulnerability by establishing a man-in-the-middle position between an affected device and its configured TCP syslog server and then maliciously modifying the TCP header in segments that are sent from the syslog server to the affected device. A successful exploit could allow the attacker to exhaust buffer on the affected device and cause all TCP-based features to stop functioning, resulting in a DoS condition. The affected TCP-based features include AnyConnect SSL VPN, clientless SSL VPN, and management connections such as Secure Shell (SSH), Telnet, and HTTPS. |
| A vulnerability in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass an access control list (ACL) that is configured for an interface of an affected device. The vulnerability is due to errors that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit this vulnerability by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to access resources that are behind the affected device and would typically be protected by the interface ACL. |
| A vulnerability in the Session Initiation Protocol (SIP) inspection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload or trigger high CPU, resulting in a denial of service (DoS) condition. The vulnerability is due to improper handling of SIP traffic. An attacker could exploit this vulnerability by sending SIP requests designed to specifically trigger this issue at a high rate across an affected device. Software updates that address this vulnerability are not yet available. |
| Multiple vulnerabilities in the Media Gateway Control Protocol (MGCP) inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerabilities are due to inefficient memory management. An attacker could exploit these vulnerabilities by sending crafted MGCP packets through an affected device. An exploit could allow the attacker to cause memory exhaustion resulting in a restart of an affected device, causing a DoS condition for traffic traversing the device. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a high rate of IPv4 or IPv6 traffic through an affected device. This traffic would need to match a configured block action in an access control policy. An exploit could allow the attacker to cause a memory exhaustion condition on the affected device, which would result in a DoS for traffic transiting the device, as well as sluggish performance of the management interface. Once the flood is stopped, performance should return to previous states. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass configured file action policies if an Intelligent Application Bypass (IAB) with a drop percentage threshold is also configured. The vulnerability is due to incorrect counting of the percentage of dropped traffic. An attacker could exploit this vulnerability by sending network traffic to a targeted device. An exploit could allow the attacker to bypass configured file action policies, and traffic that should be dropped could be allowed into the network. Cisco Bug IDs: CSCvf86435. |
| A vulnerability in the detection engine of Cisco Firepower Threat Defense software could allow an unauthenticated, remote attacker to bypass a configured Secure Sockets Layer (SSL) Access Control (AC) policy to block SSL traffic. The vulnerability is due to the incorrect handling of TCP SSL packets received out of order. An attacker could exploit this vulnerability by sending a crafted SSL connection through the affected device. A successful exploit could allow the attacker to bypass a configured SSL AC policy to block SSL traffic. Cisco Bug IDs: CSCvg09316. |
| Multiple vulnerabilities in the Application Layer Protocol Inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerabilities are due to logical errors during traffic inspection. An attacker could exploit these vulnerabilities by sending a high volume of malicious traffic across an affected device. An exploit could allow the attacker to cause a deadlock condition, resulting in a reload of an affected device. These vulnerabilities affect Cisco ASA Software and Cisco FTD Software configured for Application Layer Protocol Inspection running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCve61540, CSCvh23085, CSCvh95456. |
| A vulnerability in the Sourcefire tunnel control channel protocol in Cisco Firepower System Software running on Cisco Firepower Threat Defense (FTD) sensors could allow an authenticated, local attacker to execute specific CLI commands with root privileges on the Cisco Firepower Management Center (FMC), or through Cisco FMC on other Firepower sensors and devices that are controlled by the same Cisco FMC. To send the commands, the attacker must have root privileges for at least one affected sensor or the Cisco FMC. The vulnerability exists because the affected software performs insufficient checks for certain CLI commands, if the commands are executed via a Sourcefire tunnel connection. An attacker could exploit this vulnerability by authenticating with root privileges to a Firepower sensor or Cisco FMC, and then sending specific CLI commands to the Cisco FMC or through the Cisco FMC to another Firepower sensor via the Sourcefire tunnel connection. A successful exploit could allow the attacker to modify device configurations or delete files on the device that is running Cisco FMC Software or on any Firepower device that is managed by Cisco FMC. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| A vulnerability in the Secure Sockets Layer (SSL) VPN functionality of the Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause a reload of the affected system or to remotely execute code. The vulnerability is due to an attempt to double free a region of memory when the webvpn feature is enabled on the Cisco ASA device. An attacker could exploit this vulnerability by sending multiple, crafted XML packets to a webvpn-configured interface on the affected system. An exploit could allow the attacker to execute arbitrary code and obtain full control of the system, or cause a reload of the affected device. This vulnerability affects Cisco ASA Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, Firepower Threat Defense Software (FTD). Cisco Bug IDs: CSCvg35618. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass file policies that are configured to block files transmitted to an affected device via the BitTorrent protocol. The vulnerability exists because the affected software does not detect BitTorrent handshake messages correctly. An attacker could exploit this vulnerability by sending a crafted BitTorrent connection request to an affected device. A successful exploit could allow the attacker to bypass file policies that are configured to block files transmitted to the affected device via the BitTorrent protocol. Cisco Bug IDs: CSCve26946. |
| A vulnerability in the cryptographic hardware accelerator driver of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a temporary denial of service (DoS) condition. The vulnerability exists because the affected devices have a limited amount of Direct Memory Access (DMA) memory and the affected software improperly handles resources in low-memory conditions. An attacker could exploit this vulnerability by sending a sustained, high rate of malicious traffic to an affected device to exhaust memory on the device. A successful exploit could allow the attacker to exhaust DMA memory on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the FTP inspection engine of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability exists because the affected software fails to release spinlocks when a device is running low on system memory, if the software is configured to apply FTP inspection and an access control rule to transit traffic, and the access control rule is associated with an FTP file policy. An attacker could exploit this vulnerability by sending a high rate of transit traffic through an affected device to cause a low-memory condition on the device. A successful exploit could allow the attacker to cause a software panic on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the multi-instance feature of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to escape the container for their Cisco FTD instance and execute commands with root privileges in the host namespace. The attacker must have valid credentials on the device.The vulnerability exists because a configuration file that is used at container startup has insufficient protections. An attacker could exploit this vulnerability by modifying a specific container configuration file on the underlying file system. A successful exploit could allow the attacker to execute commands with root privileges within the host namespace. This could allow the attacker to impact other running Cisco FTD instances or the host Cisco FXOS device. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
